Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

Pitch and Turn Thumbknob control/animation

Recommended Posts

I have a question regarding the use of Lua (latest version) with the Aerosoft Twin Otter extended version. The part of the Lua script which I have been working with is the element which allows the Pitch and Turn thumb knob and dial to be operated using separate toggle switches. 

The Lua functions (in the Aircraft Module for the Aerosoft_DHC6) are

               TW AP PITCH thumbknob up

TW AP PITCH thumbknob dn

TW AP BANK thumbknob up

TW AP BANK thumbknob dn

TW AP BANK thumbknob show

I have successfully programmed two toggle buttons for the pitch and turn respectively (following a slight modification to a couple of the parameter signs mentioned elsewhere on the forums).

Curiously only the PITCH knob is animated when up or down is selected, the BANK thumbknob (Dial) is not.

I am guessing that addition of the ‘TW AP BANK thumbknob show’ function was added to get round this problem, but it does not seem to do anything I can observe.  I have spent some time trying to track down an Lvar which results in the dial animation but with no success.

Any thoughts or suggestions would be much appreciated.

Share this post

Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...