Jump to content

CRJ Service Pack 1a released

Recommended Posts

CRJ Service Pack 1a for FSX, FSX:Steam, Prepar3D v3.4 and Prepar3D v4.3/4.4 has been released.


Please use the Aerosoft Updater to get the update. A full installer is now also available in your shop account.

Below you'll find a list of the changes in this version.


Version / Rev 367
- [Fixed] Pushbutton clickspots in P3D v4 VC models
- [Fixed] Differential Pressure going off limits when lower altitude is selected
- [Changed] Some changes with Nearest Lists (airports, VORs, NDBs, etc.) updating to avoid CTD on range change
- [Fixed] VNAV issue which cause "above" constraints to be handled as "at" constraints in descent phase
- [Fixed] MFD ADV page ignored L/R setting and only allowed paging for on-side MFD
- [Fixed] No more Nav-to-Nav transfer if a non-LOC approach is selected
- [Fixed] Enabled STAR and transition selection
- [Added] Arrivals page now allows to select runways without an approach procedure (VFR)
- [Fixed] High cabin altitude fluctuation at low flight altitudes
- [Fixed] A condition where a waypoint entered on FPLN page 1 would disappear
- [Fixed] A lonely "DIRECT" indication on FPLN page 1
- [Fixed] The "Cabin Secure" callout is now triggered by closing the main door
- [Fixed] Armed vertical mode is now disarmed when ALT is pressed (GS remains armed)
- [Fixed] Entering waypoint as first waypoint of the flightplan on FPLN page 1 is now possible
- [Fixed] Total distance calculation (FPLN page 1) is now available all the time after departure and arrival have been entered
- [Added] Active airway is shown on FPLN page 2 and following
- [Fixed] Warning/Caution now comes up when engine is starting with any door open
- [Fixed] FCP ALT light doesn't go off anymore when selected altitude is changed
- [Fixed] Dubrovnik (LDDU) Rwy 12 MOKU4C SID turn second (INTC) now turns into the right direction
- [Fixed] Moved HGS radio altitude indicator further down to not block FPV symbol anymore
- [Fixed] TOC calculation for climb with combination of BELOW and ABOVE constraints (LGAV 03R/VARI1J)
- [Fixed] Improved change from (INTC) to DME Arc/Radius to fix legs (LGSM RW27/URNI1C)
- [Fixed] Improved switching to next waypoint at end of DME Arc

  • Like 1
  • Upvote 5
  • Downvote 1
Link to post
Share on other sites
This topic is now closed to further replies.
  • Create New...