LHR_EGLL_Aviation 0 Posted December 27, 2018 Share Posted December 27, 2018 Hello, I was recently on the Aerosoft A419 and there was an engine failure (Both engines), and immediately after, my flight control surfaces stoped. Is this meant to happen because in the FSLabs, after turning on the APU, it all works fine but not in the aerosoft. Also if there is a way to keep your FCSs going, can someone please tell me? Thank you. Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4161 Posted December 28, 2018 Deputy Sheriffs Share Posted December 28, 2018 The Aerosoft Airbus does not simulate failures, nore Non-SOP. so when you have an engine failure, your aircraft was for sure somehow not correctly configured. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.