Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
LuisVargas

mcdu1 do not showing speeds after upgrade to 1.2.2.0

Recommended Posts

As shown in the image mcdu1 at lower pedestal panel is not showing the speeds and altitudes constraints but the speeds and altitudes are show in the expanded mcdu (SHIFT+3).

 

A319-MCDU-ISSUE.thumb.jpg.9d8cf62238fa10833d61db8fb1ca2733.jpg

 

 

 

 

 

 

Share this post


Link to post

Just a little info:  We're not seeing this on internal test (newer) versions.  Maybe something went wrong with the install, as nobody else has yet told us of this issue with version 1.2.2.0. 

 

 

 

Share this post


Link to post

If I'm not completely wrong than the picture shows to different states. 

the internal one is at the wind page and the expanded one is at the speed page.

 

Could it be that the picture shows the internal left and expanded right MCDU ?

Share this post


Link to post

Using arrow keys left & right into MCDU you can chance the state of those two different pages.

The arrow symbol <  > in top right corner shows there is more than one pages to select.

Share this post


Link to post

I made other flights and noticed that 'the issue' only happened once (the first time I saw it) and it is not happening anymore. It may have been some mistake of me. For me you can close this post. Thank you.

Share this post


Link to post

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
Guest
This topic is now closed to further replies.

×
×
  • Create New...