pack 35

Checklists and Lvars for button actions

Recommended Posts

Hi,


I'm building my own cockpit with tablets and touchscreens to handle buttons (OVH, PDS, FCU)  with FSUIPC Lvar and Events. The idea is to not use the mouse. I could share some piece of software when finished...

But I'm stuck with some buttons which are needed to pass checklist :

  •     OVH Radio power On
  •     Cockpit record On
  •     Pred w/S power On
  •     Unlock cockipt door (to have a good coffee 😉 [Click and drag to move] ).

 

How to handle those buttons with lvars or event ?
I didn't find them in any documentation.

 

Thanks in advance,

Regards,

 

Pack

Share this post


Link to post
Share on other sites
On 12/16/2018 at 9:05 PM, pack 35 said:

Hi,


I'm building my own cockpit with tablets and touchscreens to handle buttons (OVH, PDS, FCU)  with FSUIPC Lvar and Events. The idea is to not use the mouse. I could share some piece of software when finished...

But I'm stuck with some buttons which are needed to pass checklist :

  •     OVH Radio power On
  •     Cockpit record On
  •     Pred w/S power On
  •     Unlock cockipt door (to have a good coffee 😉 [Click and drag to move] ).

 

How to handle those buttons with lvars or event ?
I didn't find them in any documentation.

 

Thanks in advance,

Regards,

 

Pack

 

Later when I'm back home I'll write you the Lvar commands you asked

Share this post


Link to post
Share on other sites
On 12/16/2018 at 9:05 PM, pack 35 said:

 

  •     OVH Radio power On

AB_OVH_RADIO_POWER (set 1 for "ON")

  •     Cockpit record On

AB_OVH_FLTRCD_BUTTON (But I'm not sure about this one...)

  •     Pred w/S power On

AB_WX_PWS

  •     Unlock cockipt door (to have a good coffee 😉 [Click and drag to move] ).

AB_COCKPIT_DOOR_STATUS_SW

 

 

 

Lvar commands above

 

Ciao

Share this post


Link to post
Share on other sites

Hi,

Thanks Klisura, it works !

But one question : how did you manage to find those values ?

 

My last point is to be able to handle doors, not easy....

 

Thanks and regards,

 

Pack

Share this post


Link to post
Share on other sites

I use Spad.Next.

I manage almost everything by switches.

I assigned doors to a switch by programming the sequence of buttons to press on mcdu. Spad.next allows to do this

Share this post


Link to post
Share on other sites

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.