Jump to content

ADIRS IR 2 Fault/ECAM Select Problem


Jimall

Recommended Posts

About half the time  that I start the A320/321 in a cold and dark state, the ADIRS IR2 indicates a fault light (above the IR2 Nav switch).  Happens even before I apply any power to the plane.    Nothing I do will cause it to extinguish except for shutting down and restarting the sim.  Very annoying.  Even if I choose "Turn Around State" it stays lit.

 

Another problem (also intermittent) is that when I select any function of the ECAM such as APU, ENG, etc. it goes to that selection on the screen but then immediately goes back to the Door display.  Won't stay on the selection I choose.

Jim

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use