Jump to content

Trim resetting


darenf

Recommended Posts

Guys

   I set the takeoff trim on the ramp and at the right place in the checklist. However when i start the takeoff roll i get a master warning that the trim is out of position.

Every time i take off i have to reset the trim as it has usually re-trimmed all the way down.

 

Can someone help please? - What am i doing wrong?

 

Cheers

Daz

Link to comment
Share on other sites

Well, there are two possibilities where you have to set trim values.

Perf-Page : 1/UP0.8  (for example)

F/CTL : normal 0, you have to set 0.8 Manual

 

Think About that the Bus automatic trim at flight, no manual trim required

Please login to display this image.

 

Regards, Wolfgang

Link to comment
Share on other sites

HI

  Thanks for taking the time to reply and advice of your settings and the process.

I have done a variety of testing over the last 24hrs and followed your advice -  which incidentally was what i was doing too. See screen shot.(although i don't have * on the TO SHIFT line for some reason)

 

the settings stay fine until a line up and then it flips down to 4.0DN. i have to manually reset.

 

Any ideas?

 

Daz

Please login to display this image.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use