darenf 0 Posted September 22, 2018 Share Posted September 22, 2018 Guys I set the takeoff trim on the ramp and at the right place in the checklist. However when i start the takeoff roll i get a master warning that the trim is out of position. Every time i take off i have to reset the trim as it has usually re-trimmed all the way down. Can someone help please? - What am i doing wrong? Cheers Daz Link to comment Share on other sites More sharing options...
Hoffie3000 96 Posted September 22, 2018 Share Posted September 22, 2018 Well, there are two possibilities where you have to set trim values. Perf-Page : 1/UP0.8 (for example) F/CTL : normal 0, you have to set 0.8 Manual Think About that the Bus automatic trim at flight, no manual trim required Please login to display this image. Regards, Wolfgang Link to comment Share on other sites More sharing options...
darenf 0 Posted September 23, 2018 Author Share Posted September 23, 2018 HI Thanks for taking the time to reply and advice of your settings and the process. I have done a variety of testing over the last 24hrs and followed your advice - which incidentally was what i was doing too. See screen shot.(although i don't have * on the TO SHIFT line for some reason) the settings stay fine until a line up and then it flips down to 4.0DN. i have to manually reset. Any ideas? Daz Please login to display this image. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.