Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
Meyerflyer

"ENTER DEST DATA" overlays entered data, that has not been inserted yet

Recommended Posts

Hello,

 

shouldn't the "ENTER DEST DATA" line in the MCDU dissappear when clicking something on the MCDU? It always shows up after some seconds, and disrupts inputs into the MCDU quite a bit. It even disturbs entering the required destination data. I can't imagine, the real bus behaves like this.

 

The main thing here is, that the indication overlays data, that has been entered, but not yet inserted into the MCDU. So I type the required winds at destination for example. Even while typing, the indication comes up again and the wind dissappears until after pressing another key. I then have the result, that I either can't see if I typed correctly before I insert the data, or if I want to make sure it's correct, I have to add another character, to make the indication dissappear for 2-3 seconds, which I of course have to delete again before inserting it.

 

Can you please have a look at this? I think there's something wrong.

Share this post


Link to post

I know, but it doesn't delete the message, that just lets it dissappear for 2-3 seconds and then it comes back. I am not able to get rid of it, until I enter the DEST DATA, that is required. I assume, the indication should go permanently, but it doesn't.

Share this post


Link to post
vor 23 Minuten, rutrA85 sagte:

You need to enter QNH, TEMP and Wind, then should be gone

 

Thanks, but I know which data to enter and where. The problem is not, that it does not dissappear after entering the required data, but as long it is not entered, the indication overlays data I want to enter, which disturbs working with the MCDU.

Share this post


Link to post

For example when I want to enter the Wind 260/8 at the according MCDU page, I begin to enter 26... and then, while typing, the "ENTER DEST DATA" indication comes up and my wind data I began to enter is no longer visible (but still there, when I press CLR, the "ENTER DEST DATA" dissappears and the wind is displayed again), only to re-appear a few seconds later and overlay the data again. Happens all the time at every flight.

 

Hope this was clear enough. Can't make it any clearer except for a video. But as this issue is always there, I'm sure you can reproduce this.

Share this post


Link to post

I understand what you are saying - perfectly clear :)
 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...