Jump to content

Tromsö ENTC and Ortho4XP


Recommended Posts

  • Administrator

Hello,

 

there was a small mistake in some manuals for Tromsö and the theme "Ortho4XP" (Page 17).

Stairport Sceneries has send us the following corrected text:

 

Copy the DEM.rar file in "Aerosoft - ENTC Tromso - Mesh" to a temporary folder and extract the included files.

Delete the folder "Aerosoft - ENTC Tromso - Mesh" afterward if you already have installed it into the Custom Scenery folder.

Open the Ortho4XP.cfg and add ENTC to the “do_not_flatten_these_list”. Should look like this: do_not_flatten_these_list = [‘ENTC’]

Start Ortho4XP and select and build the tile +69+018 as usual, EXCEPT next step.

Do this instead:

In step 2 select “Custom DEM file” and navigate to the extracted .tif file and select the one of your current tile.

In step 2 lower your “Curv_tol” setting to get a reasonable amount of mesh triangles. A setting 2.4 results in aprox. 4 million triangles. The screenshots were made with a setting of 0.8 resulting in aprox. 8 million triangles.

When the build process is finished make sure that the zOrtho4XP_+69+018 entry is below the “Aerosoft - ENTC Tromso - Airport” entry in the scenery_packs.ini.

 

We will actualize the manuals .....

Greets Heinz

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use