Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
mifra01

P3D native ATC and PFPX flightplans

Recommended Posts

Hello Flightsimmers,

 

I'm a little confused! I found out recently that PFPX-flightplans apparently are not correct interpreted by P3DV4 - no IFR-clearance is possible! Is this a new bug? Is this normal? Or have I missed something? Any help would be appreciatet. Thank's in advance.

 

Michael

 

 

Share this post


Link to post

I'm flying a PFPX flight plan this very moment from EGLL to YMML in the PMDG 777LR using the P3Dv4 ATC - it works fine, and even the AUSOTS Track YM13 is read fine by the P3Dv4 flight planner. Now its important to be sure that your navdata is updated/correct, I use FSAerodata to update my P3D database and Navigraph Ultimate for FMS data/charts/maps.

Share this post


Link to post

Hello Pracines,

 

thank you for your answer. In the meantime I solved the problem. My mistake was it to safe a scenario in P3D with a flightplan already loaded in a later state. In this way it seems not possible to bring the guys from P3Ds ATC to accept a new IFR-flightplan - they just ignored it. So I saved the whole scenario without a loaded flightplan and voilá - it no works! Fine!

 

Cheers

Michael

Share this post


Link to post

I have the same issue. Had set up a flightplan (GCFV to LPMA) in PFPX and exported it as PMDG .rte to get the whole plan into the FMS and on the other hand in the P3D .pln format to get the exact route accepted by the default P3D ATC. While loading the .pln into P3D it changes the entire routing via VORs far away from the original routing :/ 

Share this post


Link to post

There is a bug in the P3D v4 flight planner that requires us to load a PFPX flight plan TWICE in P3D for P3D to use the PFPX plan. On the second time it loads it will load the correct plan from PFPX.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...