curt1 23 Posted August 4, 2018 Share Posted August 4, 2018 I'm using the most current version on P3D 4.3. I'm not having any problems with GS capturing, that's going very well. I have noticed, however, that if I set an altitude to descend to and level off early (by selecting the ALT), that the ALTS annunciation remains armed when it should clear. If I then capture the GS at this stage, the ALTS and GS both remain armed in white even though I'm descending properly. I checked the manual on this, and it confirms the ALTS armed mode should have cleared. Link to comment Share on other sites More sharing options...
curt1 23 Posted November 6, 2018 Author Share Posted November 6, 2018 I still have this issue as reported before. Has this been looked at, please? Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3695 Posted November 6, 2018 Developer Share Posted November 6, 2018 I haven't seen this recently and I've been flying a lot. Which version of the CRJ do you currently use? Link to comment Share on other sites More sharing options...
curt1 23 Posted November 6, 2018 Author Share Posted November 6, 2018 According to the updater I have 1.2.2.0 installed. Yesterday's flight was going perfectly with a descent altitude set of 5,000. I decided to level off early at 5,500 by pushing the ALT button, and the GS captured just fine at that higher altitude. As in other flights before, the ALTS and GS indicators remained white even though I was descending just fine through the final to landing. I know that if I had leveled off at the 5,000 altitude set initially, that the GS would have gone green at capture. I hope my explanation makes sense, and I'm a bit surprised others haven't mentioned this before. Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3695 Posted November 7, 2018 Developer Share Posted November 7, 2018 I'm using 1.2.2.3 right now which can be obtained by enabling experimental updates in the Aerosoft Updater. I'm not exactly sure when, but I made a couple of changes on the AP indications. 1.2.2.3 might already fix it. Link to comment Share on other sites More sharing options...
curt1 23 Posted November 8, 2018 Author Share Posted November 8, 2018 I updated to the 1.2.2.3 and just slewed up for a quick approach. See the attached image, and you'll see the localizer and the glideslope have been captured, but the ALTS and GS still show armed. I didn't use the MCDU for this, just dropped in the ILS frequency. Please login to display this image. Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3695 Posted November 17, 2018 Developer Share Posted November 17, 2018 This is fixed in the next update. Link to comment Share on other sites More sharing options...
curt1 23 Posted November 24, 2018 Author Share Posted November 24, 2018 Great, thank you, Hans! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.