fluewa 5 Posted July 25, 2018 Share Posted July 25, 2018 Hi, when using Zurich my orthophoto tile for that area is overriden. Is there a way to either use my ortho’s only or a combination of both? Regards Perry Link to comment Share on other sites More sharing options...
fluewa 5 Posted July 25, 2018 Author Share Posted July 25, 2018 My scenery sequence is: Aerosoft LSZH Airport Zurich v2.0 a ” b ” c ... yOrtho4XP_Overlays zOrtho4XP_+47+008 Link to comment Share on other sites More sharing options...
Administrator Heinz Flichtbeil 1609 Posted July 25, 2018 Administrator Share Posted July 25, 2018 Hello, A possibility is to move only the part "Aerosoft LSZH Airport Zurich V2.0 c" with the scenery_packs.ini to the end of this ini file. Part c is the mesh folder (and all sceneries behind a mesh, x-plane will not see...). But if you have any "global" mesh (like AlpilotX Meshes...) installed, then the zurich mesh must positioned above the global mesh sceneries. So Part c must positioned in the scenery_packs.ini behind your Ortho4XP textures. Then the nearby airports , Orthos ... are ok... Please see here too. Its an older post, but will work with XP11 too. Greets Heinz Link to comment Share on other sites More sharing options...
fluewa 5 Posted July 25, 2018 Author Share Posted July 25, 2018 Many thanks, Heinz, for your quick reply. Your suggestion worked fine for me. I am glad I finally asked and sorted out my home base Cheers Perry Link to comment Share on other sites More sharing options...
Administrator Heinz Flichtbeil 1609 Posted July 25, 2018 Administrator Share Posted July 25, 2018 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.