LSZH Prof and ORBX GES ---- HOTFIX

[masterhawk 433]

Hi, this is an unoffical hotfix for LSZH Prof in combination with ORBX GES.

This will fix the default tower and the strange textures around the airport.

Just copy paste/replace the 2 files inside

"Prepar3D v4\Ecosystem\Aerosoft\Mega Airport Zuerich V4\Scenery"

 

LSZH Prof 1.00 HOTFIX1.zip

 

 

[Mathijs Kok 32198]

Thanks!

[sydney1962 35]

the default tower I could only remove, when disabling manually the three LSZH files  in GES Scenery folder,

the files in the fix only removed the strange textures.

 

rgds

 

 

[masterhawk 433]

20 hours ago, sydney1962 said:

the default tower I could only remove, when disabling manually the three LSZH files  in GES Scenery folder,

the files in the fix only removed the strange textures.

 

rgds

 

 

Hi, you must have some other settings. I have the ORBX files active and the default tower is gone with my fix. Just checked it again.

Is ORBX above Zurich in your lib?

[sydney1962 35]

no, I have all sceneries none orbx above orbx.files.

but was easy fix , only didn't know that LOWS and LSZH files were in GES intregrated.

was looking in others places then in GES Files.

[Herman 937]

Just to be clear, did you use the configuration tool in FTX Central to place Orbx below all your other add-ons? That's the correct ordering. Do register at the Orbx forums website if you haven't already for the best possible support for their products. You'll find a dedicated section to optimizing compatibility between Orbx and other products.

[sydney1962 35]

hello Herman

 

I am already 5 years forum member of Orbx , and I am quite regular visitor.

also is stated that aerosoft lszh is not compatible because of some reasons I will not discuss

here. but as always with some tricks , it is possible to scenery workable.

 

 

 

[masterhawk 433]

On 28.12.2017 at 9:45 PM, sydney1962 said:

no, I have all sceneries none orbx above orbx.files.

but was easy fix , only didn't know that LOWS and LSZH files were in GES intregrated.

was looking in others places then in GES Files.

Ok, I don’t know what then is the reason. At least there are now two options to get rid of the default tower.

[Yolo Swaggins 15]

Will there ever be an official compatibility patch? There are still issues: sunken river and ponds, mesh incompatibility and trees overlapping with autogen trees.

[Mathijs Kok 32198]

Sorry, I am unaware of any such plans.