Tony kim 1 Posted December 10, 2017 Share Posted December 10, 2017 Hi I arrived an airport and Engine cut off ... after a while i tried to ignition for engine start but STAB trim is not in the acceptable range "green range" between NU ~ ND It shows 15.0 that almost top of NU Do i need to cold and dark to reset green zone of STAB trim NU~ND ? Documentation was written that STAB trim is not simulated so need to skip Do you have any idea or procedure? Thanks Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3694 Posted December 12, 2017 Developer Share Posted December 12, 2017 I think you confuse two things here. The two STAB TRIM buttons on the center pedestal are not fully simulated, that much is correct. However, the stabilizer trim itself is of course simulated since it's almost as important as having engines. You can use the elevator trim commands (Keypad 7 and 1 with Num Lock OFF or the the respective buttons on your joystick) to control the stabilizer trim. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.