dkinder5063 6 Posted August 2, 2017 Share Posted August 2, 2017 So I just completed a flight to MCI and had a problem on the approach. After disconnecting the autopilot to hand fly the approach, the Stab Trim kept running to the full nose down position no matter what I did. I would adjust the trim to where I want it but then it ran full nose down again. Is this an error or did I do something wrong? The three previous flights I did not have this problem. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted August 3, 2017 Aerosoft Share Posted August 3, 2017 Are you sure there is not a trim command set up on your controls? Link to comment Share on other sites More sharing options...
SLKVP 18 Posted August 3, 2017 Share Posted August 3, 2017 I just found the reason for the FULL NOSE UP trim.... Right clicking on the trim yoke switches while sliding the mouse, the trim switch is 'stuck' on the not netral position. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted August 3, 2017 Aerosoft Share Posted August 3, 2017 Okay, we'll check that out. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted August 3, 2017 Aerosoft Share Posted August 3, 2017 Code is checked and there is nothing that can be further done to prevent this without removing the complete repeat option. So for now this is a limitation, don't click and drag. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted August 3, 2017 Aerosoft Share Posted August 3, 2017 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.