!! Windows 7 no longer supported !!

As Microsoft will stop supporting Windows 7 on Jan 20th we will be unable to test any of our
products on that platform. It may work, or it may not, but no guarantees from our side. 

Jump to content

Archived

This topic is now archived and is closed to further replies.

prabin747

Control Stability of Flight Factor 757 v2

Recommended Posts

I have been using FSX for almost 2 decades, and recently also started using X Plane 11. I rarely have issues flying any aircraft. Within X Plane 11, I had no issues with control stability of the default aircraft like the MD-80 or the Cessna-172 . However, Flight Factor 757 seems to be wobbly. I have tried various settings for control sensitivities but to no avail. I used to fly the Level D 767 within FSX and it was very stable. I thought flying the 757 would not be very different.

 

However, I am having serious issues flying the aircraft. There is constant oscillation in response to the primary control inputs. The response to elevator trim is also not subtle. The control inputs are also slow to react. I am using Saitek Yoke and Throttle system for Aileron, Elevators, and Thrust control and Logitech Z axis for the rudder. I am wondering if anyone encountered these issues. I have watched YouTube videos where I see a little more stability. Maybe I am missing something here. I am not enjoying flying the Flight Factor 757 V2 manually. I am surprised.

 

Any advice would be very helpful.

Share this post


Link to post
Share on other sites

This all sounds as if there is either a problem with controller calibration / sensitiity, or frame rate.

 

What is your usual FPS with the aircraft? You need at least 20 FPS, otherwise the sim will be in slow motion, affecting everything from control inputs to systems behavior.

Share this post


Link to post
Share on other sites

I get around 34 FPS. I don't think FPS is an issue. I agree it might have to do with the controller calibration/sensitivity. What would you recommend?

 

 

Share this post


Link to post
Share on other sites

Were you ever able to adjust your control sensitivities or figure out how to make it less wobbly? I'm having the same issue.

Share this post


Link to post
Share on other sites

I have not been able to resolve it. However, with the new XPlane update maybe something will change. I will try it out tomorrow.

Share this post


Link to post
Share on other sites

×
×
  • Create New...