Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

Archived

This topic is now archived and is closed to further replies.

ols500

AES not recognizing fly tampa st. maarten is installed

Recommended Posts

I know, I know this topic has been asked before but please don't close me down! I have the most recent version of AES (2.45) and I have st. maarten installed, but AES isn't recognising it. I have tried the AESA_TNCM_FTL.cfg error/fix but it makes the jetways disappear. If you have any suggestions to this problem it would be appreciated :)

 

-Captain Ols

 

Share this post


Link to post

Please check that you habe installed the last version/patch of the scenery as well.

Share this post


Link to post

Then you should have the Version 1.8 of St. Maarten.

There you should have the files maarten_term_outside.BGL and maarten_jetway5_lib.BGL in the SCENERY Subfolder of the St. Maarten Addon.

The both are there, AESHelp should see the Scenery as installed. If the jetways not shown, please check also to press the Resync/Repair Button below the Airportliste before restarting the FS.

Share this post


Link to post

×
×
  • Create New...