Jump to content
Mathijs Kok

Madeira Mesh Mega Topic

Recommended Posts

To show what I mean:
 

Normal view

2020-7-24_17-41-46-340.jpg

 

After moving the viwpoint below a certain level:

2020-7-24_17-41-51-821.jpg

Share this post


Link to post
Share on other sites
2 hours ago, mopperle said:

So every thhing else is OK? Then it is a problem to the viewpoint combined with some limitations in the engine and the fact that Madeira is extremly complex to modell.

If so, everything works as intended.

Yes, it works as intended but the viewpoint. This occurs only with LPMA. The scenery LPPS doesn't have such defective viewpoint and it was installed from the same Madeira X Setup. I don't see such viewpoint on others sceneries in my system but LPMA only so far. 

Share this post


Link to post
Share on other sites
2 hours ago, mopperle said:

To show what I mean:
 

Normal view

2020-7-24_17-41-46-340.jpg

 

After moving the viwpoint below a certain level:

2020-7-24_17-41-51-821.jpg

Yes, that's exactly I am talking about. Is that problem can be corrected? It is only the LPMA doing that in my system. It happens in P3Dv4.5 and also in FSX SP2.

Share this post


Link to post
Share on other sites
16 minutes ago, trisho0 said:

Is that problem can be corrected?

No, as said this is due to limitations in FSX and also P3D. I've seen this on other airports as well.

Share this post


Link to post
Share on other sites
20 hours ago, mopperle said:

No, as said this is due to limitations in FSX and also P3D. I've seen this on other airports as well.

If that viewpoint is due to FSX and P3D sim why LPPS looks fine without viewpoint problem? I checked several sceneries and they look fine so far. I have very complex scenery like FT Las Vegas and no viewpoint issues. The LPMA is the only scenery with such problem so far in my system.

Share this post


Link to post
Share on other sites
46 minutes ago, trisho0 said:

If that viewpoint is due to FSX and P3D sim why LPPS looks fine without viewpoint problem? I checked several sceneries and they look fine so far. I have very complex scenery like FT Las Vegas and no viewpoint issues. The LPMA is the only scenery with such problem so far in my system.

LPMA is special, because it is not based on ground like LPPS or 99% of any other airport scenery, it is on a bridge construction. And you want to see below this bridge from outside the airport, but this is only possible, when there is no mesh ground below, which blocks the SIMers viewpoint to move below the ground of the runway here.

The aircraft can be blocked by a platform command to fall down, but the Sim did not block the viewpoint for moving down at the plattfrom level.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...