Jump to content

Remaining fuel on board


Recommended Posts

Ok so i'll remove CI6 from PFPX and replace it with M.78 ?

14 minutes ago, srcooke said:

What figure did you enter for reserve, final + altn?

 

Are you going to land with less than final?

 

 

I entered 2.2 FINAL RES + ALTN

Link to comment
Share on other sites

What was the fuel at takeoff compared to PFPX.

 

What climb mode is in use.

 

The EU Fuel policy is very exacting which with the varying figures the NGX FMS is producing may trigger the reserve fuel warning. That is why I suggested creating a copy of the policy and adding a captain/company reserve, even if it's the Ryanair 300kg :)

Link to comment
Share on other sites

Takeoff fuel was 4659 in both cases.

 

I think its the strong tailwind its knocking it off. 60kts at FL370. Can you check this?

 

Yeh i have all RYR docs/SOPs from a RYR FO. And that is true ;)

 

How do i mend it to 300kg ?

Link to comment
Share on other sites

1 hour ago, Driver170 said:

Ok so i'll remove CI6 from PFPX and replace it with M.78 ?

Go ahead a use a CI6 in PFPX and the NGX FMC. The target speed on the climb and descent page in the FMC needs to be changed to 280/.78. That will make it agree with PFPX. If you are climbing to FL390 or 410 most of the flight is going to be at climb or descent. No wonder the fuel remaining does not agree between PFFX and the NGX FMC.

Link to comment
Share on other sites

16 minutes ago, Driver170 said:

Takeoff fuel was 4659 in both cases.

 

I think its the strong tailwind its knocking it off. 60kts at FL370. Can you check this?

 

Yeh i have all RYR docs/SOPs from a RYR FO. And that is true ;)

 

How do i mend it to 300kg ?

 

Place the attached in the FuelPolicy folder, you'll need to restart PFPX for it to load.

 

Tailwinds have not shown that issue here on six flights.

 

Using CLB-1 or CLB-2 modes can lead to greater fuel burn.

RYANAIR-EU-OPS.policy

Link to comment
Share on other sites

I found my problem. There has been double waypoints on my last flight thats why it was under. Somehow PFPX exported the same route waypoints as LOREL3G. I just placed MCT at the top of my route MCT.

2 minutes ago, srcooke said:

 

Place the attached in the FuelPolicy folder, you'll need to restart PFPX for it to load.

 

Tailwinds have not shown that issue here on six flights.

 

Using CLB-1 or CLB-2 modes can lead to greater fuel burn.

RYANAIR-EU-OPS.policy

 

Did you just amend that policy?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use