Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Fabrice77

  • Rank
    Ramp Agent
  1. Hello All, I have a mesh issue with LSGG: 1. Gates 1 and 2 are not flat. Front gear is lower that rear gear. (see Gate 1-2 file attached. 2. The area between the Arena and the WTC is a mess. (see Arena file attached) 3. The cargo area is not flat (see cargo file attached 4. Taxiway A is bumpy, as if it was grass/earth instead of concrete. Part of the INNER taxiway, near the round satellite is the same. I tried everything, including full reinstallation, but cannot find a solution. This is happening with both standard or Ortho4XP mesh. With a standard or freeware airport, this is not happening as well. Does anyone have the same issue and/or a solution? Thanks a lot, Fabrice
  2. Hi All, I bought the new Geneva add-on for x-plane. I use Ortho4XP, so I rebuilt the tile using the included patch. Despite this, I have the following issues: 1. The area of gates 1 and 2 is sloped. Going to one of these gates, we clearly see that we are going down. 2. The area near the cargo apron shows "stairs" and is not flat. also, the taxiway alpha going to runway 22 is bended. These points do not exist if I use the included mesh. Also, SAM is wrongly configured and ask the plane to stop way too close of the terminal building (on all gates), having the jetway almost parallel to the building... I'm using the FF A320 exclusively, so not sure if this is with all planes. Is there any solution for this? Thanks a lot, Fabrice
  • Create New...