-
K. Elcipse vs Katana
Diamond learned how to lighten the airframe during the tail end of the Katana production run. I occasionally got to fly a lighter Katana during flight training. It made a noticeable difference in the way it flew. Jordan, if you are looking to buy a DA20, I can put you in touch with my mechanic. He has worked on both models and can give you a good idea on what to expect from an owners perspective. For example, the Rotax engine has two carburetors that need to be in sync. On the other hand, fine tuning the Continental's fuel injection can be somewhat tricky. Both models have a good reputation for being easy to maintain. There are two type clubs that are a great source of information http://www.diamondaviators.net http://www.diamondaviator.org
-
Flight Control Lock
I hear that! I want to figure out a way to get my girl Holli into the simulation! David
-
K. Elcipse vs Katana
Hi Jordan, While waiting for Snave, I might be able to answer some of your questions. I have a Katana (DA20-A1), but I haven't flown the Eclipse (DA20-C1) yet. The Eclipse has the more powerful Continental engine (125hp) and is rated for a higher useful load. It's engine is not compatible with constant speed props so either a climb or a cruise optimized fixed pitch prop is used instead. The C model also requires mixture adjustments, but has no carburetor heat control since it's (mechanically) fuel injected. The seats are much improved over the A model, but I've found that Oregon Seat cushions help minimize the differences. The Eclipse also has rear windows which help with right traffic patterns. Most recent Eclipse's have Garmin 430's as standard equipment and are now available with the Garmin G500 glass cockpit. Alas, like the Katana, the Eclipse is not IFR certified. Good luck with your pilot license. David
-
Scratches...?
I wouldn't get away with that in the real world! My Katana is parked outside, in a part of the airport that must double as a bird sanctuary Cleaning is a regular part of my preflight. I'd move into a hanger, but, in San Diego, they go for $400/month! I wouldn't be surprised if the Katana4X's dirt simulates increased drag. Katana wings are free of rivets and suffer from less parasitic drag than aluminum wings. It's important to keep them clean for max speed and efficiency. David
-
Emergency Landing
So you fly IFR ... "I follow roads" It's always good to have an 'out'.
-
Thank you
I finally got some time to do some maneuvers. Starting from preflight, I did a touch and go, then flew over to the Del Mar practice area and did some steep turns and slow flight. Then I practiced some approach to landing stalls and take off and departure stalls. Finally, I wrapped up with a return to Montgomery and parked back at Pacific Wings. The whole flight really felt authentic. There were a few minor differences. For example, the cylinder heat temp was cooler than my Katana (I'm envious!) and the throttle settings were a bit different. Overall, though, the modeling was quite accurate. Thanks for all your hard work. This project shows a lot of attention to detail. It will be a pleasure to use this simulation when planning my cross country trips. David
-
Loss of RPMs...
Did you apply carburetor heat for lower throttle settings? It sounds like a carb ice issue or fuel starvation. Assuming you had sufficient fuel with any water drained out, I'd suspect carb ice. Don't let the outside air fool you. It's the temperature on the inside of the carburetors that matters. A partially closed throttle causes a restriction in airflow. The suction from the engine causes the air pressure in the carburetor to drop. The air temperature drops and condensation forms. If the resulting temperature is below freezing, ice blocks the carburetor throat. A rule, I've been taught is to always apply carb heat when below 20" manifold pressure. Remember to turn it off after landing.
-
Emergency Landing
What was the oil pressure and temperature? If they were in the green, the inlet baffle wasn't an issue. If the engine ran OK after landing, it sounds like you experienced carburetor icing, but that should not be a concern if your manifold pressure was above 20". At times like this, one really appreciates the Katana's 14:1 glide ratio. That's almost double the glide ratio of typical small airplanes.
-
DA20-Katana Problem
This simulation is so accurate, it seems, that we have to visually inspect the model before engine startup! Just bringing up the Katana 4X preflight overlay might not be enough (?) The walk around is, by the way, the one aspect of preflight this is required by regulations in the real world.
-
Well uhh....
I once had an ignition switch failure. Since the Katana doesn't have a mixture control, the normal way to shut off the engine is to ground both ignition circuits (ignition switch to off). My only other option was to shut off the fuel supply. At first that didn't work either! There I sat, trapped in an airplane that wouldn't stop. I couldn't open the canopy since it might get damaged in the prop wash. After a few minutes, the engine finally stopped! Rotaxes sip fuel.
-
High CHT?
If you are going to tweek the engine simulation, you should also look into max RPM during the runup. It should go all the way to max even when the airplane isn't moving. On my first simulated Katana 4x flight, I couldn't get the RPM above 1700. On my real Katana, I have to set 2000 RPM in order to cycle my prop. I thought there was a problem with my throttle hardware. I eventually tried a takeoff, and as I started moving, the simulation increased the RPM to full value.
-
What MP do you use?
In the Limitations chapter, the simulated manual indicates 2420 as max continuous engine RPM which is consistent with the real manual. On the other hand, the simulated manual shows a max continuous propeller RPM as 2260 while the real manual shows 2420 as indicated on the RPM gauge. By the way, the Katana is the only Rotax powered airplane that indicates propeller RPM. Other Rotax airplanes indicate engine RPM which is 2.2727 times higher. In section 5.3.2 Cruising Performance in the simulated performance chapter, 2260 is referenced as the max continuous RPM. This is also different from the real version which indicates 2400RPM has max. I'm also curious about the references to fuel flow versus altitude in the simulated manual. The real manual shows fuel flow as only a function of power setting yet during a recent flight to Las Vegas at 10,500 to 11,500 feet, I saw higher than expected fuel flows. I wonder if the simulated manual might be more correct on fuel flow. As for power settings, when I fly, I like to keep the engine at 65%. I'm not in a hurry to get anywhere. My airplane is my destination David
-
High CHT?
I'm not sure if this is modeled in the sim version, but I've heard that in real life, if the Rotax loses coolant, it can run at 50% power. That works out to about 72 knots which is also the best glide speed. Last summer, on the one hot weekend we had in San Diego, my oil temp approached red line during a climb. I hoped it would cool as I got higher, but we had a temperature inversion that day and climbing only made it worse so I cut power and flew home. Overheating is an issue Katana pilots know too well.
-
Who saw the fly - have you killed them?
I hesitate to write this since I probably would not have believed it I had not witnessed it myself ... I once saw a man fly his pet mouse on a radio controlled glider. The unbelievable part was, after taking a short break, the mouse eagerly ran back into the cockpit for the next flight. It must have been really enjoying it's flight.
-
Who saw the fly - have you killed them?
A couple of years ago, I had a fly passenger on board. I left the fly alone to enjoy the view! If fly's could communicate, that one must have had quite a story to tell it's fly friends when we got back. (Your English is fine!)