Version 1.0.2
766 downloads
I wanted to create my own profile for the Toliss A321 so here it is. It is a bit different than the one that is already up here.
Alt, heading, Vs and IAS knob are what they control and obviously the adjustment knob changes up or down.
Heading button pulls the heading knob out for manual heading hold
Nav button pushes heading button for managed or follow your flight plan
apr button activates approach mode
Rev button activates loc
push altitude button it pulls the altitude knob for manual input. To put back in managed mode you still need to use the mouse on the planes alt knob
altitude lights up when in managed mode not manual mode.
push the VS button and it will pull the VS knob to activate VS (I haven't done the light for this button yet)
Push the IAS button and it will take the plane out of managed speed mode for your speed setting. The IAS light comes on when the plane is in managed speed mode.
Auto pilot button activates AP1 and lights up when active
Parking brake light comes on with parking brake
starter light comes on if either of the engines or apu starter is engaged
door light comes on and stays on until the doors are completely shut
I haven't done anti ice yet
I havent done low volts yet
Apu light comes on when apu is available
low fuel pressure comes on if any of the pumps are off or if there is a fault in the pumps
Aux fuel pump I haven't done yet
Low oil pressure comes on as soon as the engine oil pressure has dropped below engine 1 or 2 normal idle oil pressure
hyd pressure light comes on if it drops below normal operating range in all hyd systems
engine fire comes on if either engine is on fire
I did not do vacuum yet
master warning and caution come on when there is a warning or caution.
I left the flap switch to be used for your desire. I wanted to use the flap switch for flaps instead of the lever
If you put throttle 3 and 4 down past the idle position it kills the engine switch and when you put the lever back to idle it turns it on 3 does engine 1 and 4 does engine 2
Both reversers are programed if you have the commercial levers
I am sure I am forgetting something but let me know what yall think. Its my first submission of a profile. Hope you enjoy and feel free to give feedback.