Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

okleber

members
  • Content Count

    32
  • Joined

  • Last visited

Community Reputation

2 Neutral

About okleber

  • Rank
    Flight Student - Groundwork
  1. I have exactly the same issue. Installed 1.2.1 from scratch several times and everything works. Let AS Updater install 1.2.1.5 and the lower ECAM stays locked on the doors page. The ECAM page select butttons are all inop and the checklist requires a "skip item" at ECAM recall. In addition if I ignore the issue and continue to start the engines N2 and EGT are increasing but N1 stays at 0 and the plane is in an "undefined" state. The engine sound plays N2 and EGT are fine but N1 is 0 even if power is applied. If I stick with 1.2.1 the problems don't appear.
  2. Just did the same flight LFMN to EGLL 9L that crashed twice yesterday again, however this time without AI traffic and AES disabled. It worked fine, no crash nor memory problem. Plane was the CS757 as yesterday. Oliver
  3. The crashes are only partly related to the PMDG 747. Flew into EGLL yesterday using an ifdg/PSS merged airplane, had no problems landing on 27L. Today with the CS757 two crashes at the very same spot on final to 9L. As mentioned several times already taking off from EGLL is ok. And btw. I do have the 3GB switch activated. Oliver
×
×
  • Create New...