All Aerofly FS2 support
All Aerofly FS2 support
13 topics in this forum
-
Pinned topics
-
- 0 replies
- 410 views
-
Topics
-
- 0 replies
- 147 views
-
- 3 replies
- 576 views
-
- 0 replies
- 438 views
-
- 0 replies
- 361 views
-
- 0 replies
- 376 views
-
- 2 replies
- 432 views
-
- 2 replies
- 695 views
-
- 1 reply
- 813 views
-
- 0 replies
- 1340 views
-
- 1 reply
- 1279 views
-
- 5 replies
- 1887 views
-
- 9 replies
- 1559 views
-
Posts
-
Hi Randy - thanks for getting back to me. To be honest I don't know what got into that state. The speed was 190 (set by me) with flaps, so I'm not sure how it decided to go into an alpha floor state - at other times those speeds have not been an issue. After all of that, I had to restart the auto throttle, but it always acted in the same way. I gave in with the flight, but I will try again. -
-
Kind of hard to see on my iPad, but low airspeed and high AOA initiated alpha floor protection. Perhaps your throttle wasn’t set properly? Randy -
Hi I've been having a lot of problems using these Airbuses lately - but on this occasion the a319. I you look at the cockpit settings , I can'the see a problem with any of my settings, but the system has reacted real bad. Firstly, it was set to 190kts, with flaps set to one, but all of a sudden my aircraft was over 300kts and I was getting an alarm (it was also set to A/FLOOR) ! I had done nothing to get that - the autopilot was set to 190kts and had flats set to 1, why did it react like (I'm sorry you can hardly hear my voice in the video, but its not that appropriate if you keep an eye on the systems. Gary 2019-03-26 00-10-10.mp4
-
By CheapCharlie · Posted
I would love AS or another development group publishing under AS create an MD-11 package, with similar complexity as the AS 32 bit BUS or DA CRJ, for Prepar3d 4.X.
-