Manual Flight, Autoflight and Flight Management

All discussions and questions about the Flight Management system and autoflight (autopilot etc) and manual flight.

302 topics in this forum

  1. Pinned topics
    • 0 replies
    • 452 views
  2. Topics
    • 153 replies
    • 14878 views
    • 151 replies
    • 14049 views
    • 57 replies
    • 3130 views
    • 49 replies
    • 3746 views
    • 44 replies
    • 4034 views
    • 31 replies
    • 2362 views
    • 30 replies
    • 2052 views
    • 29 replies
    • 961 views
  3. FMS PROG CTD

    • 28 replies
    • 2178 views
    • 26 replies
    • 3156 views
  4. my CRJ-700 can't climb

    • 25 replies
    • 2627 views
    • 25 replies
    • 1944 views
    • 24 replies
    • 3669 views
  5. FMS 'Load Route' ...

    • 24 replies
    • 853 views
    • 23 replies
    • 4166 views
    • 22 replies
    • 1950 views
  6. Altitude hold

    • 21 replies
    • 1382 views
    • 21 replies
    • 1502 views
  7. Load a saved flight

    • 21 replies
    • 916 views
  8. How to change runway

    • 19 replies
    • 1120 views
    • 19 replies
    • 1505 views
  9. RNAV Approaches

    • 18 replies
    • 2120 views
  10. Trim authority

    • 16 replies
    • 798 views
    • 16 replies
    • 865 views
  • Posts

    • View File Eurowings Hertz 100 Years livery Repaint of Eurowings Airbus A320 D-ABDU in the Hertz 100 Years special livery. For Aerosoft Airbus A320 Professional for P3D V4   Instructions & CFG Entry in the readme. Submitter LIAMD3012 Submitted 02/17/19 Category Aerosoft A320/A321 professional liveries  
    • I suspect you are using an outdated shortcut still linked to your old .exe as you appear to suggest the program runs.   Delete any shortcut and start from the programs list
    • The above image of the flight plan was obtained after restarting P3Dv4 and reloading the a/c and flight plan.  Unfortunately, I did not think to get a shot when the problem was first noticed.   Harold
    • Hallo zusammen, Ich habe einen neuen PC gekauft und musste so mein FSX neu aufsetzen. Nun habe Ich unter Win 10 das Problem, dass wenn Ich den AES ( auch in Admin Mode) starte immer nur Loading drin steht aber sich das Programm nicht öffnet. Was kann Ich hier tun?   Gruß Dominik
    • Nah, i don't have any errors. I even have on " Automatically check for new updates" on pfpx