General discussion and support

Please only use this section for issues that do not belong in other sections.

854 topics in this forum

    • 9 replies
    • 605 views
  1. Throttle

    • 14 replies
    • 1105 views
    • 5 replies
    • 400 views
  2. VC Yoke Hide

    • 2 replies
    • 796 views
    • 6 replies
    • 578 views
    • 4 replies
    • 650 views
    • 17 replies
    • 1313 views
  3. SkyCam cameo

    • 4 replies
    • 296 views
  4. Life stream

    • 4 replies
    • 343 views
    • 5 replies
    • 516 views
    • 4 replies
    • 314 views
    • 3 replies
    • 338 views
  5. Install error

    • 3 replies
    • 291 views
  6. Performance

    • 1 reply
    • 473 views
    • 2 replies
    • 217 views
  7. SkyCam

    • 1 reply
    • 553 views
  8. Pop-UP for DAVE

    • 1 reply
    • 403 views
  9. Lighting Issue

    • 4 replies
    • 452 views
    • 10 replies
    • 1510 views
  10. Speed AP

    • 5 replies
    • 596 views
    • 6 replies
    • 385 views
    • 3 replies
    • 1472 views
    • 1 reply
    • 415 views
    • 1 reply
    • 592 views
  11. Sound problems

    • 2 replies
    • 763 views
  • Posts

    • Ah, that's an easy one.  From what I'm seeing, all you need to do is click the square shown in the graphic below, however this may well force more scaling to take place unless you first go into the P3D Options, Graphics Settings, and change your resolution to match the resolution of your monitor.  If you need to know what the monitor resolution is, you can open the NVIDIA control panel (if you have an NVIDIA card), go to the Display section and Change Resoltion sub-section and check to see what the native resolution is (see second graphic below for these settings).  Then set that same resolution in P3D Graphics Options.   Now your P3D display should fill your entire monitor.  Hopefully this will help resolve the issue for you!    
    • Thanks for that very detailed and descriptive response, Dave!  How would I go about making my P3D window the same size as my monitor?  In the meantime I will download and run DDU as recommended.
    • Hi!  It says “Not responding”,
    • Also, I just Googled "P3dv4 CTD when using menu" and came up with a very good thread about this over at AVSIM.    https://www.avsim.com/forums/topic/530304-p3dv41-crashes-opening-options-menu/  
    • Same problem here.   I downloaded from aerosoft shop.I can install, but after installation I don't get the finish and reboot screen.   When I try to uninstall, I get an error ' no logfile found'. ASupdater is not present, or says that there's no product installed. I cant see trueglass installing.   I can fly the plane, by the way.Only with the error I am showing at the picture.   Regards,   Martin Pampiermole