Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
  • Posts

    • I noticed today, when the Eng mode selector is selscted to start/ign, the packs turn off normally, and if you take too long to start the engines they then turn back on (like the real plane). I then tried to start an engine and to my surprise it wasn't able to start normally with packs on! Of course, the APU doesn't have enough bleed pressure to start an engine and also run both packs at the same time.
    • EDIT: Responding to Hans's request FSX SP2 -  WIn7 SP1 - CRJ  1.2.3.0   Battery On  Dome Lights On (it is dark at the time of the test)  LAMP TEST 1 -> AVAIL light on (along all other)  LAMP  test OFF I request ground power AVAIL light on    PS: I did not follow the hint I state on previous post         
    • Ich ehrlich gesagt auch nicht. 🙂
    • Hello everyone, they cancelled the photo of my FlyErnest livery request. This should work. 
    • *No problem Mathijs, I read you clearly. Thanks for pointing that out. I have being communicating with FSDT forum in that regards. This started to happen after activating their latest Update. lots of trouble with it. So far got the GSX it's working again, however the Jetways created with Lv2 Expansion before the new update are not appearing. Very tedious process and no resolution yet.    FLR   *Thanks Mop...Will chk that out even thou I am not to clear yet how to proceed on your advise so working on it. Just a quick note: I just completed a flight with the A321 (KMIA to KATL) and surprisingly did completed with no freezes, great but very weird!!!...however the checklist got stuck at (After Takeoff) and did not advance. I did did thrusted back the lever and the CLIMB did not lift up as well the remaining checklist did not functioned. Basically, I did the rest of the flight manually since I was more concern that PD3 would crash, Very weird!!!. I will do another flight here in a few minutes to verify. Btw!..Its there a manual remedy to skip to the next checklist on the FMC panel if it happens again??   FLR
×
×
  • Create New...