Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

Twin Otter Extended

Support for the Aerosoft Twin Otter Extended

919 topics in this forum

    • 18 replies
    • 6007 views
    • 2 replies
    • 576 views
    • 5 replies
    • 3032 views
    • 2 replies
    • 994 views
    • 13 replies
    • 1395 views
    • 0 replies
    • 890 views
    • 26 replies
    • 4510 views
    • 2 replies
    • 1402 views
  1. GNS 530 colors

    • 11 replies
    • 1812 views
    • 2 replies
    • 631 views
    • 0 replies
    • 827 views
    • 6 replies
    • 838 views
    • 0 replies
    • 1040 views
    • 0 replies
    • 809 views
    • 0 replies
    • 753 views
    • 0 replies
    • 1270 views
    • 11 replies
    • 1052 views
    • 16 replies
    • 2830 views
    • 4 replies
    • 1427 views
  2. Changing Models

    • 2 replies
    • 463 views
    • 20 replies
    • 7167 views
  3. engine temperature

    • 9 replies
    • 2391 views
    • 3 replies
    • 734 views
    • 0 replies
    • 982 views
    • 8 replies
    • 4671 views
  • Posts

    • That is a Shader issue.  We don't recommend the use of third party shaders with the Airbus.  If you're not using any third party shaders, did you delete the P3D shaders after updating P3D?   Best wishes.  
    • This is a fairly common procedure - which many of us old-timers do so automatically that we don't realise it could be a stumbling block to some.   In your aircraft.cfg, each livery will have an entry - starting with [fltsim.0]. These all need to be sequential, so the next block of values for the next aircraft should start with [fltsim.1] ... and so on. If you already have a fair few liveries added, then your new [fltsim.x] entry should be the last entry plus one. It sounds to me like you may have a mistake in the numbering <?>.   If there's a mistake, the sim processes all the entries up to the mistake - so you still get the original ones showing.   Adam.    
    • Started over again and it seemed to work this time. Hit a glitch somewhere, very odd.   Also this was from a Cold and Dark start via the C&D menu option.
    • FMGC gives the optimum speed. If you want something different i suggest pulling speed and selecting your desired one.
    • Hi The check lists stop after a go around and clean up
×
×
  • Create New...