Jump to content

unable to use Airbus X


Recommended Posts

I have read the forum on how to set up my saitek rhino x 55 throttle. I have done everything. My stick moves in the cockpit but nothing happens with the throttles. I went into the aerosoft launcher and tried setting that up as well but nothing seems to work. It's hard to fly when the throttles don't work. Help please.

Link to comment
Share on other sites

Hello;

Did you use the Airbus configurator,to set up your joystick for the aircraft,it has selections there for throttles,how many are on your joystick.

Mark

Link to comment
Share on other sites

I just set the ailerons and elevator with the stick. I chose on the throttle configure each axis for a throttle. I don't know what else to do. I don't want to let it sit in the virtual hangar. Right now I have controls set the same in fsx controls. I'm stumped.

Link to comment
Share on other sites

I just set the ailerons and elevator with the stick. I chose on the throttle configure each axis for a throttle. I don't know what else to do. I don't want to let it sit in the virtual hangar. Right now I have controls set the same in fsx controls. I'm stumped.

Link to comment
Share on other sites

  • Deputy Sheriffs

As I also use the x55 and have no problem, did you run the FSX as Administrator? And, btw. the launcher is not intended to be used for throttle setup in this case.

Do you use Saitek's drivers? If so, try it without them.

Link to comment
Share on other sites

I've done the FSUIPC tutorial and ini editing. Still no luck. I didn't install the drivers. Just plugged into USB ports and fly. It recognizes in FSUIPC when I move each throttle separately. I'll keep trying.

Link to comment
Share on other sites

  • Deputy Sheriffs

There should be a link under Start/Proramms/Aerosoft.... or you open it from the Product folder under FSX/Aerosoft/Airbus....

Link to comment
Share on other sites

  • Deputy Sheriffs

Start -> Programs -> Aerosoft -> Airbus -> Airbus A318-319 (or Airbus A320-321) -> Aerosoft.Airbus.X. Configurator

Link to comment
Share on other sites

I searched everywhere but couldn't find it. I uninstalled and then re installed and found it. My throttle is set to 2 axis. FSUIPC is set up correctly, when I open aerosoft launcher and go to configure joystick, it has the axis already visible in X and Y axis so it recognizes it. I was able to get it to move in the cockpit but only from all the way back to just idle, no further. I am getting closer. Any more suggestions?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use