rpaddy 0 Posted September 27, 2014 Share Posted September 27, 2014 Hello guys, With the previous version I haven't this problem. But with the 2.36 in every airport default or Aerosoft during the pushback, the aircraft bouncing . I've try with Douglas dc9 coolsky and Leonardo Maddog, Bae 146 . Can anyone help me about? Thanks so much Roberto Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted September 27, 2014 Deputy Sheriffs Share Posted September 27, 2014 I do not see this problem with 2.36. Did you try the Repair button? Link to comment Share on other sites More sharing options...
rpaddy 0 Posted September 27, 2014 Author Share Posted September 27, 2014 Hi, yes I had just try with repair button, but same thing! Link to comment Share on other sites More sharing options...
krielkip 7 Posted September 27, 2014 Share Posted September 27, 2014 You could try this: 3.) Aircraft is jumping or crashes while PushbackWhen you make the pushback and the aircraft is jumping or generate a crash, the "static_cg_height" and "static_pitch" values in the aircraft.cfg of the aircraft is not set optimal. Place the aircraft at an AES activated airport and start AEShelp/AESConfig. At the "Set Aircraft Parameters" page, you find the "Repair for Push" Button. Press this button once, then save and exit the config. Reselect the Aircraft in the FS to reload the aircaftconfig and try the push again. It is possible, that the automatic calculation of the values by AESConfig will not correct this problem. In this case, start AESConfig again and press the Button "Reset Push to default", then the original values are back in place in the aircraft.cfgWhen the AESConfig button don't help, you can try to find the correct values in the following way: Go to the <fs9>\Aircraft\... or <FSX>\Simobjects\Airplane\... Folder and find the folder related to the aircraft having the problem In that folder you find the aircraft.cfg Search for "static_pitch=" which is in the [contact_points] section Then place the aircraft somewhere in the FS and switch to the "Slew" Mode (default key Y) and back to normal, and you will see that the aircraft will move up and down or change his pitch, when you switch between Slew and Normal. Now, try to change the "static_cg_height" Value in small step's (+- 0.10), save the CFG file, reselect the aircraft in the FS (to reload the new cfg) and check the switch Slew/Normal again. If the aircraft changing the pitch, try the same with "static_pitch" When the aircraft is not anymore moving while the switch over between Slew and Normal mode, the push will work without jumps and crashes. For the PMDG 737 NGX following values should work correct:static_pitch=-0.60 static_cg_height=8.20 For the PMDG 777 try this: static_cg_height=13.70 Link to comment Share on other sites More sharing options...
rpaddy 0 Posted September 28, 2014 Author Share Posted September 28, 2014 Thank you krielkip, But I try both metods without solved my problem. Now remain to try the last, modify the aircraft cfg . Link to comment Share on other sites More sharing options...
rpaddy 0 Posted September 28, 2014 Author Share Posted September 28, 2014 Solved!! Ok the problem was in aircraft config dc9 and md80 both. I found inside at acft.cfg a aes value for static cg height and delete them. Now works fine Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.