Aes 2.36 aircraft bouncing during pushback

[rpaddy 0]

Hello guys,

With the previous version I haven't this problem. But with the 2.36 in every airport default or Aerosoft during the pushback, the aircraft bouncing .

I've try with Douglas dc9 coolsky and Leonardo Maddog, Bae 146 .

Can anyone help me about?

Thanks so much

Roberto

[mopperle 4162]

I do not see this problem with 2.36. Did you try the Repair button?

[rpaddy 0]

Hi,

yes I had just try with repair button, but same thing!

[krielkip 7]

You could try this:

3.) Aircraft is jumping or crashes while Pushback

When you make the pushback and the aircraft is jumping or generate a crash, the "static_cg_height" and "static_pitch" values in the aircraft.cfg of the aircraft is not set optimal.

• Place the aircraft at an AES activated airport and start AEShelp/AESConfig. At the "Set Aircraft Parameters" page, you find the "Repair for Push" Button.
• Press this button once, then save and exit the config.
• Reselect the Aircraft in the FS to reload the aircaftconfig and try the push again.

It is possible, that the automatic calculation of the values by AESConfig will not correct this problem. In this case, start AESConfig again and press the Button "Reset Push to default", then the original values are back in place in the aircraft.cfg



When the AESConfig button don't help, you can try to find the correct values in the following way:

• Go to the <fs9>\Aircraft\... or <FSX>\Simobjects\Airplane\... Folder and find the folder related to the aircraft having the problem
• In that folder you find the aircraft.cfg
• Search for "static_pitch=" which is in the [contact_points] section

• Then place the aircraft somewhere in the FS and switch to the "Slew" Mode (default key Y) and back to normal, and you will see that the aircraft will move up and down or change his pitch, when you switch between Slew and Normal.
• Now, try to change the "static_cg_height" Value in small step's (+- 0.10), save the CFG file, reselect the aircraft in the FS (to reload the new cfg) and check the switch Slew/Normal again.
• If the aircraft changing the pitch, try the same with "static_pitch"
• When the aircraft is not anymore moving while the switch over between Slew and Normal mode, the push will work without jumps and crashes.

For the PMDG 737 NGX following values should work correct:
static_pitch=-0.60
static_cg_height=8.20

For the PMDG 777 try this:

static_cg_height=13.70

[rpaddy 0]

Thank you krielkip,

But I try both metods without solved my problem. Now remain to try the last, modify the aircraft cfg .

[rpaddy 0]

Solved!!

Ok the problem was in aircraft config dc9 and md80 both.

I found inside at acft.cfg a aes value for static cg height and delete them.

Now works fine