P3D v2.3 - "problem deserializing panel state while loading a flight..."

[DukeSan27 2]

"...problem deserializing panel state while loading a flight..."

I get this every-time I load a flight with Airbus. What does it mean and how to fix it?

Thanks

[Bobit 0]

I have exactly the same problem, any help on this issue appreciated.

[Tom A320 4915]

I saw that once when starting P3D directly into the bus. When following the suggested way (starting into a small default plane and then switch over into the bus) I have never had that problem.

[Manolix 1]

Options/ Settings/ Display.../ General/ (uncheck Panel Serialization box)

[DukeSan27 2]

I saw that once when starting P3D directly into the bus. When following the suggested way (starting into a small default plane and then switch over into the bus) I have never had that problem.

Options/ Settings/ Display.../ General/ (uncheck Panel Serialization box)

Need to load default aircraft every time?

Does not saving panel state mean that the plane is not the same as when it was saved?

[Manolix 1]

Duke, At least in my case, every time I save a flight and assign it default, is always there when I open the simulator without any message "problem deserializing panel ..."

[DukeSan27 2]

I un-checked panel serialization, and the bus flies fine, so I guess all's well.