DMacAir1 12 Posted May 22, 2014 Share Posted May 22, 2014 Simmers and Devs, Just a question regarding the jetway covers that extend from the jetway to the aircraft, I've noticed that, at many airports, the AES seal that comes from the jetways is far smaller than where the existing scenery developers have placed the seals. This sounds confusing, so I've included an image to make this clearer. As you can see, at FB KDEN here, the seal only extends inside where the seal should extend from to the aircraft. Just wondering, is this something that has the potential to be improved upon in a later update? -Derek Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted May 22, 2014 Deputy Sheriffs Share Posted May 22, 2014 Picture? Link to comment Share on other sites More sharing options...
DMacAir1 12 Posted May 22, 2014 Author Share Posted May 22, 2014 Just uploaded. Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted May 22, 2014 Deputy Sheriffs Share Posted May 22, 2014 Ahm i would say that the aircraft is not configured for use with AES. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted May 22, 2014 Aerosoft Share Posted May 22, 2014 To be honest I had to look at that image for some seconds to see the problem. I think this will be hard to fix, even if it would make serious sense. If the shroud would be bigger it might bigger then the modeled gate. That would be a far bigger issue then it being smaller. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.