Zackrampage 2 Posted January 13, 2013 Share Posted January 13, 2013 So I installed airac 1301 for the airbus x extended, and it's still showing up as the last airac thatcame with the plane. Any tips? Link to comment Share on other sites More sharing options...
pecheur5500 8 Posted January 13, 2013 Share Posted January 13, 2013 Hi! Navigraph? Link to comment Share on other sites More sharing options...
hejeune 0 Posted January 13, 2013 Share Posted January 13, 2013 Hi Zack, I think what you would need to do is go to NavData.ini which is in the Flight Simulator X Files Folder, Inside the airbus x extended folder. Then open it and where it says useNavDataPro=1 make sure the 1 is a 0 if you are using navigraph and it is a 1 if you are using nav data pro. Hope this helps Link to comment Share on other sites More sharing options...
Zackrampage 2 Posted January 15, 2013 Author Share Posted January 15, 2013 Can't seem to find any of these folder. Link to comment Share on other sites More sharing options...
Andy B. 40 Posted January 15, 2013 Share Posted January 15, 2013 NavData.ini should be located somewhere like this in Windows 7 English language versions; C:\Users\Your Username\Documents\Aerosoft\AerosoftAirbusExtended Link to comment Share on other sites More sharing options...
Zackrampage 2 Posted February 1, 2013 Author Share Posted February 1, 2013 Ok I tried installing latest airac following these instructions for v 1.04 but it still shows old airac. Can someone please give me the step by step? Link to comment Share on other sites More sharing options...
Pontiac51 4 Posted February 1, 2013 Share Posted February 1, 2013 This post should help you out, you just need to find your navdata.ini. I can asure you that the navigraph 1301 works, cause im using it. 1. Install AIRAC 1301 (you did get the cycle for ASX?) as usual (default folder shown by the installer should be fine). 2. Change entry "useNavDataPro=1" in navdata.ini to "useNavDataPro=0" (paths are normally correct, no change needed). 3. Go fly! [if you install an update to ASX, be sure to check the navdata.ini again, cause the parameter could have been reversed by the update.] Link to comment Share on other sites More sharing options...
Christophe M 16 Posted February 1, 2013 Share Posted February 1, 2013 Hello, So you go into your folder : C:\Users\Your Username\Documents\Aerosoft\AerosoftAirbusExtend Then you open the file : NavData.ini Then you change the ini file as follow : NavData.ini [NavData] useNavDataPro=1 (set this to 0 if you want to use NaviGraph data) pathNavDataPro=NavdataPro\NavData\ (the path to the NavDataPro folder, all paths are relative from FSX main folder) pathNavigraph=Navigraph\NavData\ (the path to the Navigraph folder, all paths are relative from FSX main folder!) Regards. Christophe. Link to comment Share on other sites More sharing options...
Graham W 67 Posted February 1, 2013 Share Posted February 1, 2013 Must remember to save the text file once you make the change otherwise it will just stay the same. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.