Hoffie3000 96 Posted July 15, 2018 Share Posted July 15, 2018 Hello, why is it not possible to set manually the Trim Data via Scratchboard like the other datas like Pax, Cargo, etc? It do not accepting letters like "Up or Down". And Numbers only result in a "Bad Format" message. But if I load the complet data via the loadsheet then the required data changes in Trim will accepted. Any ideas or suggestions here? Please login to display this image. Regards, Wolfgang Link to comment Share on other sites More sharing options...
Fragged^2 40 Posted July 15, 2018 Share Posted July 15, 2018 Trim on the load and fuel page is a calculated value based on your load and fuel set that should be used in the takeoff performance data. Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted July 15, 2018 Deputy Sheriffs Share Posted July 15, 2018 But you able to change the TRIM values in the normal MCDU TP PERF page....... Link to comment Share on other sites More sharing options...
DaveCT2003 2553 Posted July 15, 2018 Share Posted July 15, 2018 Great info in the replies. Just a little more info on this. By default the Trim value is set to .8, but it can be calculated in the Fuel Planner and sent to MCDU3. This is just for the load sheet, you must then enter the Trim in MCDU1 or 2. Best wishes. Link to comment Share on other sites More sharing options...
DaveCT2003 2553 Posted July 15, 2018 Share Posted July 15, 2018 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted July 15, 2018 Deputy Sheriffs Share Posted July 15, 2018 vor 5 Stunden , DaveCT2003 sagte: Great info in the replies. Just a little more info on this. By default the Trim value is set to .8, but it can be calculated in the Fuel Planner and sent to MCDU3. This is just for the load sheet, you must then enter the Trim in MCDU1 or 2. Best wishes. Sorry this is not completely correct. The TRIM value of the MCDU 1 and 2 is automatically updated with the TRIM value from the MCDU 3....... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.