RALF9636 28 Posted January 9, 2018 Share Posted January 9, 2018 Using Anchorage Pro together with Orbx SAK I get a lot of "steps" on the water surface of Lake Hood, making it unusable for Floatplanes. The lake is flat when SAK is disabled. The SAK-option is activated of course. Link to comment Share on other sites More sharing options...
Developer OPabst 2091 Posted January 9, 2018 Developer Share Posted January 9, 2018 We will have a look into that tomorrow. Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted January 9, 2018 Deputy Sheriffs Share Posted January 9, 2018 Do you have Bathymetry turned on? I've see strange things with this Link to comment Share on other sites More sharing options...
Developer OPabst 2091 Posted January 9, 2018 Developer Share Posted January 9, 2018 7 minutes ago, mopperle said: Do you have Bathymetry turned on? I've see strange things with this I don't think, that this is a reason for it, as flattenpolies should also flatten the see ground. But, as in the other thread, the water poly of Orbx "lift" the lake up and overrole the Airportflatten, I expect that there is a waterflatten below the lake hood too, which is not on the correct level and now conflict with the afcad of Lake Hood on the correct lever. As there a "taxiways" in the lake to make AI waterplanes possible, they will lift the wrong waterclass flatten in same areas, so it get's total in uneven state. We will check for the best solution tomorrow, as it could be reproduced by Thorsten of simwings. Link to comment Share on other sites More sharing options...
RALF9636 28 Posted January 9, 2018 Author Share Posted January 9, 2018 I have bathymetry turned off.  And indeed it kind of looks like there is an elevated taxiway network on the lake.  It becomes apparent at a mesh setting of 10m and higher (=higher detail). Link to comment Share on other sites More sharing options...
RALF9636 28 Posted January 10, 2018 Author Share Posted January 10, 2018 The visible uneven water surface on Lake Hood is fixed with 1.02. Â But there still is a problem: Â Around the western end of the island that separates the taxi lane from the takeoff / landing lane there are some spots where the floatplane gets stranded as if there was ground, not water. There are even two yellow-black taxiway markings on the lake, which probably is connected to this problem. Â Link to comment Share on other sites More sharing options...
newtie 2 Posted January 10, 2018 Share Posted January 10, 2018 Where do you get these updates? Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted January 10, 2018 Deputy Sheriffs Share Posted January 10, 2018 6 minutes ago, newtie said: Where do you get these updates? Available in your shop account Link to comment Share on other sites More sharing options...
newtie 2 Posted January 10, 2018 Share Posted January 10, 2018 Thanks. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted January 11, 2018 Aerosoft Share Posted January 11, 2018 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.