simbio 0 Posted September 7, 2017 Share Posted September 7, 2017 Hi, Is it possible in the near future that Pfpx will use speed and altitude restriction /N0450F340 inside of the flightplan. If you set in the editor it will always delete. Thank you Fabrizio Link to comment Share on other sites More sharing options...
srcooke 421 Posted September 7, 2017 Share Posted September 7, 2017 How are you setting the restriction Fabrizio ? Post an example of your entries and route. Link to comment Share on other sites More sharing options...
simbio 0 Posted September 10, 2017 Author Share Posted September 10, 2017 On 7/9/2017 at 6:42 PM, srcooke said: How are you setting the restriction Fabrizio ? Post an example of your entries and route. This is a flight from EHAM to HECA I need to stay until NERRA at FL320 then climb to final cruise due to restriction. REND1N EDUPO UZ738 MISGO UZ741 GMH UL603 DINKU UM867 VAROB DCT ROKSA UY450 NERRA UL607 KEA UN132 KUMBI UL612 BLT A16 CVO It only validates if you set: (FPL-PHCKB-IN -B744/H-SDE1E3FGHIJ3J5J6M1M2RWXYZ/LB1D1 -EHAM1600 -N0498F390 EDUPO UZ738 MISGO UZ741 GMH UL603 DINKU UM867 VAROB DCT ROKSA/N0450F320 UY450 NERRA/N0450F320 UL607 KEA UN132 KUMBI UL612 BLT A16 CVO -HECA0338 -PBN/A1B1D1O1S2 NAV/RNVD1E2A1 DOF/170910 REG/) Another example is Italy with Frai route where you need to stay below FL335 on ATS network until you reach an Intermediate waypoint and then you can climb higher. When you build a flight plan on route planner in PFPX it doesn't keep your input like NERRA/N0450F320 as on the first example, so when you try to validate all is lost. Link to comment Share on other sites More sharing options...
srcooke 421 Posted September 10, 2017 Share Posted September 10, 2017 Please login to display this image. Please login to display this image. Link to comment Share on other sites More sharing options...
simbio 0 Posted September 10, 2017 Author Share Posted September 10, 2017 Good to know, even if I would prefer in the build section! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.