BuddyDog 40 Posted September 4, 2017 Share Posted September 4, 2017 I seem to have elevator trim differences when calculating TO trim in the CRJ manager versus using "Dave". Same passenger loads, same fuel and cargo loads, same ZFW. CRJ manager is calculating trim around 6.2 degrees, Dave is usually around 7 degrees. I am wondering if I am doing something wrong? Link to comment Share on other sites More sharing options...
TrevorS 28 Posted September 4, 2017 Share Posted September 4, 2017 I speak under correction, but I suspect the trim setting was adjusted in the new build because in the original, the TO trim was not enough!! Trevor Link to comment Share on other sites More sharing options...
Developer metzgergva 210 Posted September 5, 2017 Developer Share Posted September 5, 2017 The distribution of the same total load between LM and DAVE is different. This may lead to different values after setting it. It should be equal when you do it by LM and that just look it up in DAVE as he should take the actual data. But I can verify this with Hans once he is back. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.